Home Forums DSC Technical Questions DSC 1864 Panel with PC 5108 expander

This topic contains 3 replies, has 3 voices, and was last updated by  tscoe 3 years, 4 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #12525

    breadmaker
    Participant

    I recently installed and programmed a DSC 1864 panel with a PC 5108 expander.  I did a bench top set-up fitsr, connected everything, made sure it was programmed properly, etc.  I then disconnected powere, and mounted smoke detectors and motions in permanent spots.  Several weeks later, I am reconnecting everything again, and am having a problem.  The panel does not recognize the expansion board.  How do I re-enrol the board at the keypad?

    #55982

    You don't actually have to enroll the board. Did you do section 902, wait one full minute, then 903? What did 903 show?

                                     –Ken

    #55991

    breadmaker
    Participant

    Hi Ken,

    I did as you suggested…twice.  Each time, it just shows the two keypads I have connected.

    Mark.

    #55996

    tscoe
    Participant

    Double check the jumpers on the expander bar.  J1 off, j2-3 on

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.