Home Forums DSC Technical Questions DSC Alarm Impassa

This topic contains 5 replies, has 3 voices, and was last updated by  mikewest 1 year, 1 month ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #16037

    ruebenking
    Member

    Hello,did some one can help me in programming Impassa SCW9057.i like to hook up a hardwire siren with relay.I used the output aux + and PGM 1 on the Panel.How i have to program the output? Did i have change a Zone to hardwire?i go to *8 installercode section 009 and put 05 00But do not work realy.What i do wrong?

    #68328

    Welcome to the forum.

            Did you turn OFF option 1 in section 013 to enable I/O 1 as a PGM?

                          –Ken

    #68347

    ruebenking
    Member

    Hello,

    yes have do that, but still have 12.2 Volt coming out.

    #68349

    That's what's supposed to happen. What were you expecting?

                      –Ken

    #68350

    ruebenking
    Member

    Hello,

    but the siren will sound. Need the 12 volt if someone break in and the unit will give a signal to the siren.

    #77081

    mikewest
    Member

    Did you ever figure out the program the second siren? I install the wire like you did, and programmed like you did, and moments later got a call from "them." I don't even know if it is working or not.

    It is two wire like you mentioned, one went to AUX+ and one to PGM1.

    The system is an SCW9057. Are they going to call me EVERYTIME I add a sensor or device to the system?

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.