Home Forums ITI and GE Technical Questions Networx NX-6v2

This topic contains 1 reply, has 2 voices, and was last updated by  ABLE1 5 years ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #8332

    sgantt11
    Member

    Help!!1 Manager quit and wlked off with master code . Will not tell anyone–Is there a way to return the unitto factory defaults and reprogram? :'(

    #39507

    ABLE1
    Participant

    Hello and welcome to the Forum.

    With out the "Go to Program Code" not the Master Code you have three(3) choices.

    1)  Buy a new board and wire it up.

    2)  Pay the old manager $50 for the release of the code.

    3)  Start pushing numbers on the keypad until you hit the right one.

    Other than that you are a bit stuck.

    Sorry for the bad news.

    Good Luck,

    ABLE1

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.